Patterned Imprinted Concrete Sealer - Silk Finish
Silk Finish Imprinted Concrete Sealer for Driveways and Patios.
A 'satin' look hard wearing sealer for imprinted concrete surfaces
Smartseal Imprinted Concrete sealer has been developed to give pattern imprinted concrete a silky slightly 'wet-look' finish.
- Gives Imprinted Concrete superb long term protection
- Easy to apply by sprayer or broom
- Resists oil and stain penetration
- BS5750/ISO9000 quality approved Imprinted Concrete Sealer
- Protects against colour loss and surface wear
- Will not blister or peel, hardens & seals concrete permanently
- Make sure before applying that the surface temperature is between 10 - 23°C
- Enhances the colour of the paving
- Tough, Durable and Hard Wearing
- Oil & Grease resistant
4 to 6m² per litre per coat (dependent on condition)
Brush slab to remove any dirt or debris. It is recommended that Smartseal Imprinted Concrete Sealer is applied with a Sealing Broom. The first application must be brushed into the surface whilst avoiding pooling, and allowed to dry past tacky prior to applying the second coat. Avoid application in strong, direct sunlight - do not apply if rain is likely within 3 hours of application.
Deicing salts should not be applied directly on Smartseal block paving or concrete sealers. Salt chemically reduces the temperature at which water freezes and will result in water ingress into the concrete. Subsequent freezing may result in the concrete ‘seal’ being broken by the expansion of water as it freezes and white ‘pitted’ areas may become visible.
Technical & Test Data
Smartseal Imprinted Concrete Sealer has been tested by the TRL (Transport Research Laboratory) and certified that it meets the SRV (Skid Resistance Value) for all categories of paving for local authority pedestrian areas and when heavily trafficked is suitable for special applications where risks of skidding are high as laid down in the UK Highway Authorities Tender Specification. Copies available on request.
Health & Safety
Flammable liquid. Do not smoke. Keep application area well ventilated. Wear respirator when applying. Store in a cool place. Flash point 42°C (Abel-Closed Cup). Refer to the Health & Safety Data Sheet for further information.