Residue Remover for Patios | Remove Jointing Compound Residue

Customer Reviews

Product worked well in removing residue, but needed two attempts to clear all residue. Would definitely use again if required.

By Kevin Sainsbury From Southampton

My newly-laid patio of grey Indian Sandstone was jointed with Marshall Weatherpoint 365 which was great, but left dark residue marks in many places, really spoiling the look. Our builder has experienced the problem before but assured us that the stains would fade over time. Other online search showed that the time taken to fade completely was very variable but could be up to 12 months. I came across this online and gave it a go - with amazing results! It works like magic. I used it undiluted, and the worst patches needed several applications and some good working in with a stiff brush and a little added water, but after just a few hours work my 80sq m patio is fixed! Superb product, deserves to be well known because it seems this is a very common problem.

By Martin D From Essex

top quality product and service

By Patricia rawlings From steven

Works very well as per product details

By Peter Johnson

Did nothing

By Stephen Wilson

Easy to use and it removed all the residue and the stones finish was not impaired.

By Christoher Plenty

Used this to remove easy joint (sweep in patio grout) left of the surface of a sandstone patio at 5-1 left for 20 mins then agitated then rinsed off with garden hose, worked really well.

By Jim dutson From Green Surface Clean

Easy to use product and appears to work ok on new patio. Used surplus product on old paved area and cleaned dirt and grime off with a scrub and water from hose , didn’t use pressure washer.

By Anthony Baxter

Description

Residue Remover is a powerful ecological cleaner that unlike other acid/alkaline cleaners, does not require any neutralisation process before application.

It is specially formulated to remove surface residue and contamination from natural stone paving and other surfaces where "sweep-in" compounds may have been used.

Technical

Application:

Use neat or diluted to a 1:5 ratio depending on amount of residue present
Apply with either a brush or garden sprayer
Leave the product to penetrate and break down the surface residue (5 - 60 minutes)
Agitate with a stiff brush and wash off with a pressure washer
Re-apply if surface residue remains after first application
Average coverage 6 - 8 m² per litre

Physical Properties:

Safer to use
Phosphate free
Biodegradable
Multi-use
No VOC
Low odour
PH 13 - Alkaline
Low fuming

Health & Safety:

Non-flammable. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Keep container tightly closed and in a well-ventilated place. Wear suitable protective clothing and gloves.