Oil Remover Block Paving & Concrete

Overview

A new bio-degradable approach to the removal of oil stains from block paving and concrete.

This biological oil stain remover removes and digests oil stains from floors, road surfaces, forecourts, driveways and equipment.

KEY PROPERTIES

Penetrates and lifts oil stains from even the most porous surface.
Contains a blend of biological enzymes and bacteria to digest oil stains to completion.

• Biological
• Biodegradable 

APPROVALS

• German UBA (3406-0001)
• Separator Friendly
• UK Environmental Agency report on the bacteria used in this product
  − Environmentally acceptable chemical.
  − Meets pr EN 858
  − Full report.
  − Summary report. 

APPLICATION
With an application rate of approximately 1 litre per square metre, OT8 is simple to use and lifts oil stains from the most porous surfaces.

• Shake container before use (to put bacteria into suspension).
• Water wet the oil stain before applying OT8.
• Brush into the stain until OT8 changes colour from white to brown.
• Leave for 20 minutes and water rinse.
• Then apply the absorbent powder, contained in each kit, to absorb free oil and prevent spills to surface drains.
• Sweep up and dispose of according to local regulations. Rinse clean.
• A second application may be required on porous surfaces as the biological activity in OT8 brings ingrained oil to the surface.

*Not suitable for oil stains on Tarmac − Use Bio TA.

ALTERNATIVE FORMATS
OT4 − A 50% dilution for use by cleaning contractors.
TECHNICAL DATA
Appearance Opaque white liquid Bacteria Count 2.0 × 107 cfu/ml
SG 0.96    

SAFE HANDLING AND STORAGE
Store in original containers and avoid extremes of temperature.

Technical Information

Key Properties

• Penetrates and lifts oil stains from even the most porous paving surface.
• Contains a blend of biological enzymes and bacteria to digest oil stains to completion.
• Biological &  Biodegradable
  

Approvals

• German UBA (3406-0001)  − Environmentally acceptable chemical.
• Separator Friendly − Meets pr EN 858
• UK Environmental Agency report on the bacteria used in this product
  

Applcation

With an application rate of approximately 1 litre per square metre, OT8 is simple to use and lifts oil stains from the most porous surfaces.

• Shake container before use (to put bacteria into suspension).
• Water wet the oil stain before applying SMARTSEAL OIL REMOVER 
• Brush into the stain until SMARTSEAL OIL REMOVER changes colour from white to brown. Leave for 20 minutes and water rinse.
• A second application may be required on porous surfaces as the biological activity in OT8 brings ingrained oil to the surface.
  

Not suitable for oil stains on Tarmac.

Safe Handling & Storage

Store in original containers and avoid extremes of temperature.

Customer Reviews

Write a review about Oil Remover Block Paving & Concrete and our service.