Sealer Repair Fluid (available in 5 & 25 litres) - Removes Surface Whiteness Caused By Moisture Trapped Under the Sealer.
Frequently Asked Questions
Sealer Repair Fluid for removing whiteness on Imprinted Concrete and Block Paved Surfaces
If the solvent based imprinted concrete or block paving sealers have been applied in conditions when the surface is damp this can lead to problems. Surface whiteness is the most common issue and appears over time if the sealer has been applied when the surface is damp.
Smartseal sealer repair fluid should be used when problems like patchy whiteness have appeared on the surface of existing imprinted concrete or block paved driveways and patios. Surface whiteness, peeling or flaking sealer are common issues that are easily corrected using sealer repair fluid.
Smartseal Sealer Repair Fluid will restore existing imprinted concrete sealer or block paving sealer and clear surface whiteness from imprinted concrete and block paved surfaces.
- Coverage ratio: 3 - 4 m² per litre
Sealer repair fluid is a product designed to repair incorrectly applied sealer which is lifting or sealer which has reacted with moisture during the drying process. For imprinted concrete it should be liberally applied to the affected area, left for a couple of minutes and then worked into the surface vigorously with a soft broom until the sealer goes "tacky" under your broom. This will show you have 'softened' the sealer and you then allow it to re-bond to the concrete by leaving it.
For removal of surface whiteness on block paving repeat as instructions above, but with block paving be careful not to disturb the jointing sand when working the sealer repair fluid into the surface of the blocks.
Health & Safety
Flammable liquid. Do not smoke. Keep application area well ventilated. Wear respirator, gloves and safety glasses when applying. Store in a cool place. Flash point 42°C (Abel-Closed Cup). Refer to the Health & Safety Data Sheet for further information.